Add to Cart
Dimensions(unit in "mm")
Specifications
Rated capacity | 10N / 1kg / 2.2lb 20N / 2kg / 4.4lb 50N / 5kg / 11lb 100N / 10kg / 22lb 200N / 20kg / 45lb 300N / 30kg / 67lb 500N / 50kg / 112lb 1kN / 100kg / 224lb | ||
Rated output | 2.0 mV/V | Compensated temperature | -10...+40oC |
Excitation | 3-12V | Operating temperature | -20...+60oC |
Zero balance | ±0.1mV/V | Temperature shift zero | ±0.03% R.O./oC |
Nonlinearity | ±0.1% R.O. | Temperature shift span | ±0.02% R.O./oC |
Hysteresis | ±0.1% R.O. | Input resistance | 380±30 ohms |
Nonrepeatability | ±0.05% R.O. | Output resistance | 352±5 ohms |
Creep(5min) | ±0.1% R.O. | Insulation resistance | >5000Mohms |
Safe overload | 150% F.S. | Ingress protection | ≤20N IP50 ≥50N IP62 |
Ultimate overload | 200% F.S. | Material of element | Stainless steel |
Cable | Ø2*4000mm 4-core shielded | ||
Wiring code | Compression@ Red--Power input+ Black--Power input- Green--Signal output+ White--Signal output- |
Miniature load cell FS01 is known as s beam load cell because of its feasured s beam structure,force sensor FS01 is able to measure both tension force and compression force.The sensor can convert load or force acting on it into electronic signal which is proportional to the applied force.The acting force causes deformation of the measuring element,the bonded strain gage deforms accordingly which will cause the resistance change of the wheatstone bridge,under constant power supply,the output signal between Sig+ and Sig- will change proportionally,thus the load/force can be measured by measuring the output signal from the load cell.
Strain gauge based miniature load cell FS01 outputs millivolt signal ranging -20~20mV, and signal amplification may be required for most applications, a load cell signal conditioner can be used to get -5~5V, 0-10V or 4-20mA signal which is proportional to applied force.The amplified output is can be easily processed by PLCs and data acquisition software.
The applied force can be displayed through a load cell indicator,force indicator FPT is integrated with high accuracy/low noise 24 bit Sigma-Delta ADC,sampling speed up to 960Hz makes it suitable for both static and dynamic measurement; FPT also supports Modbus RTU protocol with RS485 or RS232 communication port,amplified signal 0-5V,0-10V,0-20mV or 4-20mA is also achievable from FPT.